Practical and Helpful Tips: Lights

Your Ultimate Guide to Crown Molding and Pot Light Installation Crown molding and pot lighting installation can be done DIY using the proper tools and equipment, and having the right skills, but it can also be intimidating because walls are not always flat and nailing can be difficult. How can you achieve a beautiful crown molding? In this article, we will be focusing on a project combining standard crown molding with two-pieces of mold base trim. It is a good idea measuring the length of the wall for the crown molding so you can buy pieces that are long enough to span each wall, and to prevent scarfing pieces together. Choose the same tone if you want to use a light-colored stain, and crown molding can be installed using a hammer, handsaw, and miter box. We highly advised using brad nailer and miter saw for faster work. For a more elegant and larger look, crown molding can be combined with other trim, offering dozens of possibilities such as combining more pieces of contrasting woods for a two-tone effect. Using a one-piece crown, it can be messy because you might need ailing blocks or glue, so it is best to have a built-up crown to eliminate the frustrations associated with nailing, dealing with trouble spots easily as you install the rail trim, having a continuous and solid base to nail the crown. Most carpenters put lines and marks right on the ceilings and walls and hide them with paint. Instead of marking your walls and ceilings, an easier method is using an easy-release masking tape with at least 2 inches wide. Tape will not stick properly if the walls or ceilings are just newly painted, so you need to wait for a couple of weeks before using tape. It is a good idea leaving the easy-release tape in place until you are done painting finishing the trim. For the crown molding trim placement, with the first piece in place, you just have to place the other pieces right next to it and working around the room following the same direction for the maximum utilization of the 45-degree cuts using a miter saw. By doing so, your molding job becomes easier, and you can also use construction adhesive on the rail (even those areas where you can nail into ceiling joists and studs) for you to use just enough nails, holding the trim into its place until the adhesive sets, with fewer nail holes to fill. You have to miter the ceiling rails both outside and inside corners. When coping wall rails, it is like coping the crown but you need to stand the trim against the saw’s fence when you’re making the 45-degree miter, and install the outside corners the last to avoid coping both ends. It can be daunting and confusing having a DIY crown molding and pot installation project, so do not hesitate to contact a professional carpenter to help you. Visit our website and check the best crown molding and pot installation companies today!Practical and Helpful Tips: Lights

Practical and Helpful Tips: Lights